JQT-7500S 7.5kw 10HP Double Stage Suction Pump Air Ring Blower For CNC Router

JQT-7500S 7.5kw Double Stage Suction Pump 10HP Air Ring Blower For CNC Router

1. Specifications

Single-Phase Side Channel Blower

Three-Phase Ring Blower

2. Machine Fitting

3.Rated Products

Double Stage Ring Blower

Specifications

4. Operation
If the rated current of the motor is exceeded during operation, the voltage and frequency of the power supply should be checked and compared with data on the unit rating plate. Some blowers can’t be operated over the whole range of the performance curve. Overload of the motor may occur due to excessive system back-pressure. In applications where over-pressure conditions may occur, a relief valve must be installed. The ring blower must not be subjected to shock or vibration loads.

5. Maintenance
The ring blower has a non-contact operation and does not normally require maintenance. Wearing parts are subject to the recommended maintenance intervals and are a constituent part of the applicable warranty claims. The service life of bearing parts depends on the operating hours, load, and other Influences such as temperature and operating pressure.

6. Installation
A. Transportation
Check all parts from damage during transport.
B. Installation assembly
The blowers are to be installed weather protected and are not to be stored outdoors unprotected. When the blowers are installed outdoors they must be covered. Install ring blower horizontally or vertically. Do not subject blowers to vibrations or shocks. Blower with base should be secured tightly at the site of operation on solid, even ground. The Ring Compressors can be installed in any direction, but when mounted vertically, the motor side should be upward.

C. Electrical connection
Note! Work described here must be executed by a qualified electrician only. Connect the motor in accordance with the wiring diagram to be found in the terminal box. The blower has a single or three-phase motor as described on the motor plate. The motor should be protected with an overload switch.
D. Control of rotation direction
Startup the blower for a short moment, Check the rotation direction. The rotation direction on the impeller must be in accordance with arrows on the motor. If incorrect rotation is experienced, then check the wiring circuit in the terminal box.

7. Feature
1) Beautiful surface and Small dimensions in the die-cast aluminum alloy housing
2) Both 50Hz and 60Hz are available.
3) Dual-usage: Compressor and Vacuum (suction and blow).
4) Electronic motor with IP54 protection and Insulation class F.
5) 100% oil-free and no oily odors.
6) Low noise and libration.
7) Maintenance-free and easy installation.
8) Strong dynamic stability without vibration
9) Pulsation-free discharge
10) Cooler running bearings
11) Longer grease life
12) Suitable for environmental protection
13) Continuous duty